V2 Updates – Our long-awaited v2 version features a single footswitch which allows both latching and a momentary function if the footswitch is held over 250ms. We’ve beefed up the power supply too, so any 9-18v center-negative power supply will do the job.  Also new to the v2 is an added 1/4″ input, which along with the XLR microphone loop is summed to the XLR output. This allows a solo singer/songwriter the ability to condense down to just an instrument, pedalboard, and powered speaker for most gigs!

Cusack Music Pedal Cracker Pedal V2 Controls

• Mic Gain: A clean, transparent preamp to add gain to low level microphone signals.
• Mix: Controls dry/wet mix of the FX loop.
• Volume: To control the output volume of FX loop after dialing in the Mix.
• Inst Gain: Gain control for the instrument input. Sums directly to XLR output, it does not run through the FX loop.
• Trails switch: Keeps the FX return live to preserve trails when disengaging the Pedal Cracker.

Cusack Music Pedal Cracker Pedal V2 Specs

• XLR input and output. 
• 1/4″ send and return for the FX loop. 
• Latching/momentary footswitch. Quick step to latch the FX Loop on, hold for momentary operation. 
• Instrument input jack that sums to XLR input. Helps to simplfy the cable setup of singer/instrumentalists by having one line needed to go to the mixing board or speakers. 
• Recessed switches for ground lift and 48V phantom power.
• Standard center negative 9-18v DC (not included) 
• Current draw: ~190mA
• Send – <100Ωr
• Return – 600kΩ
• 4.7″ L x 3.8″ W x 2.3″ H

More Cusack Music Products